JDS Uniphase HST-3000 Quick Card page 5

Hide thumbs Also See for HST-3000:

Now press the left arrow to go back to the

summary page. Check that the summary page

remains green. Select the Action button and

select Insert Single FCS Error.

Check that the screen has turned red and a

single error has appeared on the screen.

Quick test is now complete. Please proceed to the next section RFC 2544 testing.

4 RFC 2544 Testing Using the HST-3000

This section describes how to validate the link between two locations. The output of this test is a

go or no go on the quality of the link and the results can be saved for further analysis. This

section is expected to take approximately 20 minutes for testing.

Step

This section continues from 4.3. If you have not

completed that section, please do so at this time.

If you are ready to proceed, press the action key

and select Stop traffic.

Press the configure button. Tap the left and

right arrows until you get to the Summary

Settings Screen. Then select RFC 2544 Mode

and press Symmetric.

Directions