JDS Uniphase HST-3000 Quick Card page 4

5 Tap right to select the Ethernet Filter Tab.
Make sure that
Destination Type -> Don't Care
Source Type -> Don't Care
Encapsulation -> Don't Care
Payload Analysis -> On
Rx Payload -> Acterna
6 Next press the home key. Then select Restart.
7 Now to Loop up the far end select the Action
Key, then select #2 Loop and then Select #1
Loop Up.
8 You should see a message at the top stating
"Remote Loop Up Successful..."... If you do
not see this message please double-check your
settings. If the message still does not appear
repeat steps 1-6 for the far end tester.
9 Now select the Action key and then select Start
Traffic. Check that the Frame LED on the top of
the unit becomes illuminated.
10 Press the right arrow to see the Link Stats and
ensure that frames are being received (Total Util
% Cur is >0).
4