JDS Uniphase HST-3000 Quick Card page 2

Hide thumbs Also See for HST-3000:

Repeat steps 1-5 (and possibly 8 and 7) until the fiber appears clean. If you repeat this

procedure three times and the fiber still appears dirty, throw out the fiber as it is likely

scratched.

2 Setup for Testing an Optical Link with the HST-3000

This section describes setup and testing when the location in the field is an optical drop.

Step

The first step is turning the unit on and then

hitting the home key. Then select the Eth

Optical tab and select option 1 1G Terminate.

The unit will now boot up. Make sure to insert the proper SFP into the R/T 1 slot (top

left of the unit). The proper SFP will be either a 1310nm or 850nm optical SFP

depending on the handoff.

The next step is to select Layer 2 Traffic as your Test selection.

Now press the configure button on the tester.

Then select RFC 2544 Mode = Disable and

Auto Negotiation and depending on the network

select On or Off (most likely this will be set to

on). Next press the home key.

Now select the Action tab and then select Laser

On.

You should see the screen turn green. If not,

select the display key and then select the

summary result pane. Then select the restart

key on the right side.

Directions