Curt Group 3025101 Installation Manual page 5

Step 7
Secure the running board to the front mounting
bracket using one M8 flat washer and one
5/16" nylock nut on each T-rail stud.
Repeat for the middle mounting bracket.
Before securing the rear mounting bracket,
place an LED light bracket over one of the
T-rail studs, as shown in the third image.
Secure each T-rail stud with one M8
flat washer and one 5/16" nylock nut.
Snug the hardware, but do not fully tighten.
Step 8
At this time, adjust the running board
to the desired location.
With the running board in position,
it is recommended to tighten all
brackets to the vehicle first, followed
by the running board connections.
Repeat steps 1 through 7
on the passenger side.
NEED ASSISTANCE? • 844.278.4357 • RA • PAGE 5