Advertisement
Quick Links
YEARS: 2018-PRESENT
MAKE:
WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY
WEIGHT CARRYING:
PRO INSTALL TIME:
NOVICE INSTALL TIME:
INSTALLATION REQUIRES:
TORQUE
WRENCH
RATCHET
SCREW
SMALL PUNCH
DRIVER
SAFETY
GLASSES
ROTARY TOOL
PRY BAR
13387
INSTALLATION INSTRUCTIONS
BMW
TRAILER WEIGHT:
5,000
LBS.
TONGUE WEIGHT:
750
LBS.
90
MIN.
MIN.
INSTALLATION TIPS:
180
MIN.
1. BEFORE YOU BEGIN INSTALLATION, READ ALL
INSTRUCTIONS THOROUGHLY.
2. TO EASE INSTALLATION, 2 PEOPLE MAY BE
REQUIRED.
3. USING PROPER TOOLS WILL GREATLY IMPROVE
THE QUALITY OF THE INSTALL AND REDUCE THE
TIME REQUIRED.
8mm
10mm
LEVEL OF DIFFICULTY: CHALLENGING
18mm
EASY
SOCKETS
PART REMOVAL
TAPE
MEASURE
PLASTIC RIVET
GUN
MODEL: X3
MODERATE
CHALLENGING
REMOVE BUMPER
AND EXHAUST HANGERS
TRIM UNDERBODY PANEL
NO DRILLING REQUIRED
Safety glasses should be
worn at all times while
installing this product .
STYLE:
VEHICLE PHOTO:
REPRESENTATIVE PHOTO
HITCH ILLUSTRATION:
MAKE SURE YOUR HITCH MATCHES
SUV
Advertisement
Related Manuals for Curt Group 13387
Summary of Contents for Curt Group 13387
- Page 1 Safety glasses should be 13387 INSTALLATION INSTRUCTIONS worn at all times while installing this product . YEARS: 2018-PRESENT MAKE: MODEL: X3 STYLE: WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY WEIGHT CARRYING: TRAILER WEIGHT: 5,000 LBS. TONGUE WEIGHT: LBS.
- Page 2 INSTALLATION WALKTHROUGH: Parts List ITEM PART NUMBER DESCRIPTION M6 RIVET NYLON RIVET (AUVECO #20754) VEHICLE FRAME EXISTING VEHICLE STUDS (BOTH SIDES) USE TO REPLACE VEHICLE HANGER (BOTH SIDES) BUMPER BEAM EXISTING VEHICLE STUDS (BOTH SIDES) EXISTING HARDWARE (BOTH SIDES)
- Page 3 INSTALLATION WALKTHROUGH: 1. Remove underbody panel by removing (10) fasteners using 3. Remove (3) rivets from wheel well trim above each tire. To 8mm socket. remove rivets push small center rod through rivet with a small punch. Pry rivets from trim. NOTE: Replacement rivets included.
- Page 4 INSTALLATION WALKTHROUGH: 7. Remove (2) nuts from each tail light using 10mm socket. 5. Remove (1) plastic clip on each side using a pry tool. Gently unclip plastic covers located on inside of each tail light. 8. Unplug electrical harness and gently remove each tail light. 6.
- Page 5 INSTALLATION WALKTHROUGH: 9. Gently unclip (1) reflector on each side of rear fascia to 11. Remove bumper beam by removing (2) nuts on each side access and remove (1) fastener on each side using 8mm using 18mm socket. Also remove (1) nut on each side from socket.
-
Page 6: Install Complete
INSTALLATION WALKTHROUGH: 13. Torque all M12 hardware to 86 ft-lbs. Torque all M8 15. Trim underbody panel. See UNDERBODY TRIM hardware to 23 ft-lbs. DIAGRAM use as reference. Reinstall underbody panel as removed in STEP 1. NOTE: All dimensions are approximate, confimr fit prior to trimming. - Page 7 CURT provides the best trailer hitches and towing.
Need help?
Do you have a question about the 13387 and is the answer not in the manual?
Questions and answers