SMC Networks HRR010-A-10 Series Operation Manual page 21

2.3 Function of Parts
Name
Operation display panel
Fluid level gauge
Power supply switch
Model label
Circulating fluid outlet port
Circulating fluid return port
Drain port
Power supply connector
Communication connector
CN1,CN2
Facility water inlet
(For water-cooled type)
Facility water outlet
(For water-cooled type)
HRR Series
The function of parts is as follows
Table 2-3 Function of parts
Runs and stops the product and performs settings such as the circulating
fluid temperature.
For details, refer to "2.4 Operation display panel''.
Indicates the circulating fluid level of the tank. For details, refer to ''3.5
''.
of circulating fluid
Shuts off the power supply to the internal eqipment of product.
Shows the part number of the product.
For details, refer to "1.4
The circulating fluid flows out from the outlet port.
The circulating fluid returns to the return port.
Port to drain the circulating fluid out of the tank.
Connect the power cable to the Power supply connector
accessory, and then plug it in.
For details, refer to " 3.3.3
".
Use for contact input / output, serial communication.
For details, refer to "3.3.3
cable ".
A facility water inlet to which the facility water is fed through piping.
The pressure of facility water should be in a range of 0.3 to 0.5MPa.
A facility water outlet from which the facility water returns to the user's
machine through piping.
Chapter 2 Name and Function of Parts
Name
''.
Product Label
Preparation and wiring of power supply cable
Preparation and wiring of power supply
HRX-OM-X084
Fill
2.3 Function of Parts
2-7