SMC Networks HRR010-A-10 Series Operation Manual page 136

HRX-OM-X084
Chapter 8 Control, Inspection, Exchange and Cleaning
5.
Remove the filter case.
Tilt the filter case to the front.
Please note that circulating fluid may flow out from the case when removing filter case.
Discharge circulating fluid inside of filter case.
After discharging circulating fluid, mount the resin filter case by hand tighten.
Filter case

Mounting of the case should be performed by hand-tighten. When
the case is tightened excessively by tools , the case might crack or
be damaged.

If the case is dropped, it may result in cracking or breakage.
6.
Use a cross slot screwdriver to install the filter panel.
(Recommended tightening torque：1.5N・m)
8.3 Stop for a Long Time
8-10
Tilt to the front
Open
Close
Caution
HRR Series