Weslo cadence G-40 User Manual page 7

1. Make sure that the power cord is unplugged.
Place a piece of cardboard under the tread-
mill frame to protect the floor during assem-
bly.
Have a second person hold the Base (52) in the
position shown.
Attach six Base Pads (63) to the Base (52) with
six 19mm Tek Screws (26).
2. Have a second person hold the Base (52) in the
position shown.
Identify the Left Upright (53) (the Right Upright
[54] has a large hole near the lower end).
Hold the Left Upright (53) so that the two
small holes for the latch assembly are on top
as shown. Attach the Left Upright to the Base
(52) with two M10 x 58mm Bolts (2); do not
tighten the Bolts yet.
Attach the Right Upright (54) to the Base (52)
in the same way.
1
26
63
52
2
Large
Hole
54
Small Holes
7
26
63
26
63
26
63
2
52
53
26
63
2