13. Attach the Latch Housing (48) to the Left Upright
(53) with two #10 x 1" Tek Screws (58); start
both Tek Screws, and then tighten each of
them.
14. Raise the treadmill to the storage position (see
HOW TO FOLD THE TREADMILL on page 19).
Attach an Incline Leg (95) to each side of the
Frame (51) with an M8 x 52mm Bolt (82), two
M8 Flat Washers (72), and an M8 Nut (46) as
shown. Note: Do not overtighten the Nuts.
The Incline Legs should rotate easily.
Adjust the Incline Legs (95) to the desired in-
cline (see page 18).
Lower the treadmill for use (see page 19).
15. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
in a secure place. One of the hex keys is used to adjust the walking belt (see page 21). To protect the floor or
carpet, place a mat under the treadmill.
13
48
58
14
82
72
72
95
51
13
53
72
72
46
46
95
82