Weslo cadence G-40 User Manual page 11

9. With the help of a second person, hold the
Console (91) near the Right Upright (54).
Remove the wire ties from the Wire Harness
(39) and the console wire. Connect the Wire
Harness to the console wire. See the inset
drawing. The connectors should slide to-
gether easily and snap into place. If they do
not, turn one connector and try again. IF YOU
DO NOT CONNECT THE CONNECTORS
PROPERLY, THE CONSOLE MAY BECOME
DAMAGED WHEN YOU TURN ON THE
POWER. Insert the connectors and the excess
wire downward into the Right Upright (54).
10. Set the Console (91) on the Uprights (53, 54).
Make sure that no wires are pinched. Start
four M8 x 15mm Bolts (8) with four M8 Star
Washers (5) into the Uprights as shown; do not
tighten the Bolts yet.
9
Console Wire
39
54
10
91
8
5
54
11
91
39
8
5
53