Panasonic KX-TVM50 Programming Manual page 127

T: Dial Tone Detection
, : Dial Pause for 1 s (default)
; : Dial Pause for 3 s (default)
X : Pager Dialling
1–9, 0, , #: Dial Codes
Feature Guide References
2.3.23 Intercom Paging (APT/DPT Integration Only)
Release for Intercom Paging
Specifies the intercom paging release code required by the PBX. This can be programmed using a
combination of the 7 letters and 12 dial codes as specified above.
Value Range
Max. 16 digits consisting of 0–9,
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause for 1 s (default)
; : Dial Pause for 3 s (default)
X : Pager Dialling
1–9, 0, , #: Dial Codes
Feature Guide References
2.3.23 Intercom Paging (APT/DPT Integration Only)
No Answer Time for Intercom Paging
Specifies the length of time (in seconds) the VPS must wait before concluding Intercom Paging when
there is no answer. The VPS will return to the caller if the paged party does not respond before this
timer expires.
Value Range
1 s–30 s
Feature Guide References
2.3.23 Intercom Paging (APT/DPT Integration Only)
Announcement Repeat Cycle
Specifies the number of times the VPS announces the page.
, # and special codes
2.5 System Parameters
Programming Guide 127