Advertisement
Weighing Operations
The illustration below shows the IQ plus 590-DC keypad and normal mode key functions.
DISPLAY
TARE
Basic IQ plus 590-DC weighing operations are
summarized below:
Toggle Gross/Net/Piece Count Mode
Press the
GROSS/NET
key to switch the display mode
between gross, net, and piece count modes. If a tare
value has been entered or acquired, the net value is the
gross weight minus the tare. If access to piece count
mode is disabled, pressing the
switches between gross and net modes only.
Gross mode is shown by the
is shown by the
annunciator. Piece count mode is
N
shown by the LCD annunciator adjacent to the
the right edge of the display.
Toggle Units
Press the
key to switch between primary and
UNITS
secondary units. The units annunciator arrow on the
right side of the LCD display points to the units
identifier.
Zero Scale
1. In gross mode, remove all weight from the
scale and wait for the standstill annunciator
(
).
2. Press the
ZERO
(
) annunciator lights to indicate the
scale is zeroed.
Acquire Tare
1. Place container on scale and wait for the
standstill annunciator (
2
IQ plus 590-DC Operator Card
NORMAL MODE KEY FUNCTIONS
ZERO
GROSS
NET
B/N
MODE
2
3
6
7
8
key
GROSS/NET
annunciator; net mode
G
PC
key. The center of zero
).
TARE
UNITS
T
Units
T
ENTER
SAMPLE
4
5
9
0
2. Press the
TARE
of the container.
3. Net weight is displayed and the
annunciator lights to show the tare value was
acquired.
Enter Tare (Keyed Tare)
1. Use the numeric keypad to enter the tare
value, then press the
2. Net weight is displayed and the
annunciator lit to show the tare value was
entered.
at
Remove Stored Tare Value
1. Remove all weight from the scale and wait for
the standstill annunciator (
2. Press the
TARE
off, indicating the tare value has been
removed.
Indicators with the REGULA parameter set to
NONE or NTEP can clear a stored tare value
using the following procedure:
1. Press
DISPLAY TARE
value.
2. Press the
stored tare.
Print Ticket
1. Wait for the standstill annunciator (
2. Press the
PRINT
the serial port.
PRINT
PRINT
POWER
I / O
key to acquire the tare weight
TARE
key.
).
key. The
annunciator goes
to show the stored tare
CLEAR
key twice to remove the
key to send weight data to
).
Advertisement
