Automation Tab; Data Source - CSSN ScanShell 1000 User Manual

Configuring the Program

Automation tab

AUTOMATION TAB

DATA SOURCE

The Data Source section determines the data input source: Scanners, magnetic strip or
image file.
Checking the 'Scanner' option does the following:
• Sets the scanner as the input image device.
• Sets the Scan button icon to a scanner image in the main screen.
• Enables the lower checkbox, titled 'Paper auto detection'.
Checking the 'Image File' option does the following:
• Sets the image source as a local image file from the hard disk.
• Sets the Scan button icon to an 'Open file' image in the main screen.
• Disables the lower checkbox, titled 'Paper auto detection'.
Checking the 'Magnetic Strip' option does the following:
• Sets the Magnetic Strip Reader as the input device.
• Sets the Scan button icon to a magnetic strip card image in the main screen.
• Disables the lower checkbox, titled 'Paper auto detection'.
Checking the 'Automatic scan size' option does the following:
(This feature is available only if the ScanShell800\N scanner is connected!)
It allows for scanning undefined document sizes and continuous scan of the full length of
the document. Once the scan is complete, the image is cropped automatically to its proper
size. This feature is useful for scanning different documents of different sizes.
Paper auto detection - Checking this option will cause the scanner (ScanShell 800, 800N,
2000) to auto-detect document insertion and start the scanning and saving process
automatically. When using the ScanShell 1000 scanner, any of the scanner buttons can be
pressed to start the scan. In addition, the scanner buttons can be configured, see next
section.
If the 'Paper auto detection' is unchecked, the scanner starts scanning when you click
on the Scan button in the main screen.
©
56
IdScan User Manual version 9.0 Card Scanning Solutions, all rights reserved