CSSN ScanShell 1000 User Manual page 46

MagshellThe main screen controls
•
types, sets the source for data detection accordingly.
•
Rotate
magnetic scan mode).
•
Zoom
applicable in magnetic scan mode).
•
the image source is set to scanner. Otherwise, activates the
Note: 'Toggle to file' is possible only if a scanner is physically connected to the PC, or if
the license key used is a temporary key.
•
Scanner (Magshell magnetic reader, ScanShell scanner, or an image file on the
hard disk).
•
Scanner
connected to the PC. A red light indicates that no scanner was found.
•
way to control the image prior to saving (not applicable in magnetic scan
mode).
•
SAVE AS dialog if file saving is enabled, or saves the file to the clipboard.
•
Toggle Image
output destination to file or clipboard.
•
a Scanshell scanner connected to the computer to allow scanning and
retrieving data from barcode or OCR).
•
verification purposes.
•
Open OCR
IdScan User Manual version 9.0
Category: selection of the scanned document
Image: Rotates the image 90 degrees clockwise (not applicable in
Image: Click to enlarge the image for better reading (not
Scan Image: Starts the image scan if using manual scan and
Toggle Image
Connection: A green light indicates that the scanner is
Delete Image: Deletes the scanned image. This gives you a
Save to File: Active only in manual save mode: Opens the
Output: Active only in manual save mode: Sets the
Card Verification: Activates the verification function (require
Toggle reference: Sets the reference source for card
View: Opens extracted text view.
©
Card Scanning Solutions, all rights reserved
Source: Sets the input image source to
File Open dialog.
46