MagshellSwiping cards
SWIPING CARDS
Once the Magshell magnetic reader is connected to the computer, all you need to do is
swipe the card through the reader.
Before scanning, you have to set up the scanning configuration. This can be done in
two ways:
1. In the configuration panel, in which you can control all the program settings,
see Magnetic reading tab, page 73.
2. Most settings can also be set up from within the application main window.
CATEGORY
• ID cards (Driver Licenses)
• General card
SCAN IMAGE
2.
connected to the PC. A red light indicates that no scanner was found. If no
scanner is detected, input of new data is not possible.
OUTPUT OPTIONS
which allows immediate pasting into another application. Active only if manual save
is selected in the configuration panel, see Magnetic reading tab, page 73. Selecting
opens the
Save to file
SWIPING A NEW DOCUMENT
Swipe a document. The scanned data will be saved according to the settings you
specified in the configuration panel, see Magnetic reading tab, page 73.
ID DATA
After scanning and processing the card, you can review the acquired text by opening
the ID Data window. To open the ID Data window, press the OCR button on the main
screen.
IdScan User Manual version 9.0
Select the scanned document types as follows:
1. Click on the arrow and select the
magnetic reader must be connected to the computer –
make sure the green lamp is on)
Scanner Connection: A green light indicates that the scanner is
Select the data output option: Save to file or copy to the clipboard,
dialog after the scan is complete.
Save As
©
Card Scanning Solutions, all rights reserved
(the Magshell
Mag. Strip
48