Program Operation; Card Insertion Auto-Detect; Category; Scan Image - CSSN ScanShell 1000 User Manual

Scanshell 800 N

PROGRAM OPERATION

Before scanning, you need to set up the scanning configuration. This can be done in
two ways:
1. In the configuration panel, in which you can control all the program settings,
see chapter 7, Configuring the Program, page 55.
2. Most settings can also be set up from within the application main window.

CARD INSERTION AUTO-DETECT

Click on this button to for automatic detection of card insertion. If this button is
pressed, scanning will start as soon as you insert a card into the scanner. If auto-detect
is not turned on, scanning starts when you click the

CATEGORY

ScanShell 800N support the following documents:
• Business cards
• Checks
• Barcodes

SCAN IMAGE

4. if
Auto-detect
button.
Note: Image file can be selected if a scanner is physically connected to the PC, or if the
license key used is a temporary key.
5.
connected to the PC. A red light indicates that no scanner was found. If no
scanner is detected, input of new data is not possible.

OUTPUT OPTIONS

which allows immediate pasting into another application. Active only if manual save
is selected in the configuration panel, see Saving options, page 58. Selecting
opens the
file
IdScan User Manual version 9.0
Select the scanned document type.
3. Click on the arrow and select the image source: Scanner
or an image file on the hard disk. (The third option
is only available if a Magshell magnetic reader is
Strip
connected to the computer)
is not selected, start the scan by pressing the
Scanner Connection: A green light indicates that the scanner is
Select the data output option: Save to file or copy to the clipboard,
dialog after the scan is complete.
Save As
©
Card Scanning Solutions, all rights reserved
Program Operation
button.
Scan Image
Scan Image
Mag.
Save to
39