Id Card Verification; To Verify A Card - CSSN ScanShell 1000 User Manual

MagshellID Card VERIFICATION

ID CARD VERIFICATION

Use this option to check if the card you are scanning is genuine. It requires a
Scanshell scanner connected to the computer. IdScan will compare the data extracted
from the card with data from the scanned card using OCR or the card's barcode). If
the data from the two sources match, the card is genuine. Else, the card is either faked,
or one of the data sources on the card is corrupted.

TO VERIFY A CARD:

1. Select a state from the State dropdown list or use the State Detect option (for
OCR). You are advised to select the state manually, because if the state is not
recognized for some reason, you'll have to repeat the process. You can also
select a state from the quick state selection buttons, if you have predefined
them. (To set a button for the desired state, right-click on the button. Select the
desired state from the list. After you release the mouse button, you'll notice
that the button name has been changed to the state you selected).
2. Use the popup menu of the card verification button to
select a second card data source, which will be used for
comparison with the magnetic reading results.
3. Click on the Card verification button to start the
verification (When the verification process is active, the icon on the button
will flash, if it's not active it will be black)
4. Swipe the card
5. IdScan will prompt you to scan the card a second time. Insert the card in a
Scanshell scanner.
6. Place the ID card in the Scanshell scanner.
7. If you are not using the Auto detect card insertion option: Click on the Scan
button to scan the data source (This scan will be saved to the database if you
will save the record).
8. If you are using the AutoDetect card insertion mode, just insert the card into
the Scanshell 800 scanner, or click the Scanshell 1000 button.
9. If the data from the two sources on the card matched, the icon on the
verification button will be green. If it did not match, the icon will be red,
which means the card is not in order, (either faked, or one of the data sources
on the card is corrupted.
10. Press OK to save the record to database.
IdScan User Manual version 9.0
©
Card Scanning Solutions, all rights reserved
52