Setup; Fill Pot With Abrasive Media - Graco EcoQuip 2 EQm Instruction Manual

Hide thumbs Also See for EcoQuip 2 EQm:

Table of Contents

Setup

1. Verify that the pot seal plunger (E) is in the DOWN

position. If the plunger is in the UP position, perform

the Pressure Relief Procedure on page 17.

2. Verify that all Installation procedures, beginning on

page 10, have been completed.

3. Close the rinse ball valve (U) and abrasive ball

valve (J).

4. Turn the selector valve (T) to OFF.

5. Open the pot dump valve (F) and quick drain valve

(ZH).

6. Prepare the pot to accept media:

To fill an empty pot: Fill approximately half the

pot (C) with water, until the water drains from

the quick drain valve (ZH). Shut the quick drain

valve.

To refill the pot during operation: Open the

quick drain valve (ZH) to drain the water until

the pot is approximately half full. Shut the quick

drain valve.

7. For systems with water tank supply only: if the

water in the tank is less than halfway full, fill the tank

with fresh water.

ti39817a

3A3489T

Table of Contents