Adjusting the Output Level of the Punch Waste Full Sensor
After installing this unit, adjust the output level of the punched waste paper full sensor unit as follows.
1)
Perform the following item in the Service mode.
- Service mode > SORTER > FUNCTION > FN-SENS2
2)
When completing the output level adjustment successfully, indicate the "OK" show up on the screen. When indicated "OK" on the screen, adjustment is finished.
MEMO:
If "NG" shows up on the screen at the step 2), retry the adjustment repeating the step 1). Should "NG" be still indicated though retrying the adjustment, check the
relative parts of the punched waste full sensor such as its attaching or connectors, etc.
Operation Check
After completion of installation, check whether punch unit operates normally by performing the punch operation from the operation panel of the host machine.