Canon Puncher Unit-BE1 Service Manual page 52

4
Installation Procedure > When installing to the saddle finisher
8) Using a supplied screw (Bind, M3 x 6), attach the included punched waste paper full sensor unit.
x2
x1
9) Using two supplied screws (TP, M3 x 6), attach the included punched waste paper box
stopper.
x2
4
Installation Procedure > When installing to the saddle finisher
Caution:
If the attached location of the stopper is wrong, the punched waste paper box will
be not secured by the stopper. This may result in the alarm of "Punched chips full
or No waste paper box".
F-4-32
4-14
F-4-31
F-4-33
4-14