Table of Contents
Advertisement
3
Controls > Removing the punch motor (M102)
Motors
Removing the punch motor (M102)
MEMO:
The figure for this procedure has the punch
front cover attached, but the procedure is
the same even if the punch front cover is
removed.
3) Remove the cable from 3 locations of the cable guide. Remove 2 connectors and 3 screws and remove the punch motor together with the mount.
3
Controls > Removing the punch motor (M102)
1) Remove the punch unit from the finisher. 2) Remove 1 stepped screw, 1 screw and remove the punch upper cover.
x3
x2
x3
x2
3-10
3-10
Advertisement
Table of Contents
