Canon Puncher Unit-BE1 Service Manual page 47

4
Installation Procedure > When installing to the finisher
15) Connect a connector of the punched waste paper full
sensor to the connector (CN4) on the puncher driver PCB.
x1
20) Raise the puncher unit, and then affix the supplied labels at the positions shown by the following illustration.
• Affix the punch jam label that "A" is printed on the label sheet to the left inner cover of the finisher.
• Affix the punch lever caution label of the user specified language under the puncher unit.
A B
4
Installation Procedure > When installing to the finisher
16) Using four screws, attach the rear cover of the finisher
removed in step 5).
17) Attach the PCB cover of the finisher removed in step 4).
18) Using two screws, attach the right inner cover of the
finisher removed in step 2).
F-4-20
19) Attach the supplied punch waste paper box.
21) Close the front cover of the finisher.
F-4-22
4-9
F-4-21
F-4-23
4-9