Canon Puncher Unit-BE1 Service Manual page 50

4
Installation Procedure > When installing to the saddle finisher
When installing to the saddle finisher
MEMO:
The equipment is secured
with packaging tapes and
cushioning materials to protect
it against vibration and shock
during transportation. Remove
all packaging tapes and
cushioning materials before
installing the equipment.
3) Using the nipper, cut out two face cover from the right
inner cover.
4
Installation Procedure > When installing to the saddle finisher
1) Open the front cover of the saddle finisher.
4) Release the hook with the flat head screwdriver, and then remove the PCB
cover of the saddle finisher.
x1
F-4-26
2) Remove four screws, and then remove the right inner cover of the
saddle finisher.
x4
F-4-24
F-4-27
4-12
F-4-25
4-12