Canon Puncher Unit-BE1 Service Manual page 55

4
Installation Procedure > When installing to the saddle finisher
21) Affix the supplied punch jam label that "B" is printed on the
label sheet to the left inner cover of the saddle finisher as
shown by the following illustration.
A B
4
Installation Procedure > When installing to the saddle finisher
22) Close the front cover of the saddle finisher.
F-4-43
23) The following parts will be no longer needed once the puncher
unit has been installed.
<Included parts>
• Punch unit fixing pin (for finisher): 1 pc.
• Punch latch unit: 1 pc.
• Screw (Bind, M4 x 7): 3 pcs.
• Punch lever caution label: 1 pc.
• Punch front cover and two screws removed from punch unit
<Removed parts from the saddle finisher>
• Screw: 3 pcs.
• Feed unit: 1 pc.
• Face cover of the right inner cover: 1 pc.
F-4-44
4-17
4-17