Punching Status Display Interface - Adtech NCT-04 User Manual

Relocation clamp forward distance
3.6.3
Test Code
Refer to "Programming Manual" 7. Relocation instructions for details

3.7 Punching Status Display Interface

3.7.1 Interface Introduction
The following Fig. 3 - 1 shows the punch status display interface:
Function
Brake mode
Single/Continuous
Punch drive
Running mode
NCT-04/03/02 Punch CNC System (Commissioning Manual)
P1.098
Fig. 3-1
Table 3 - 1 is the punch state description:
Table 3-1
Parameter
Feeding
Single stop Single stopping top dead center as off clutch signal
Double stop Single / continuous punching off clutch is controlled
Single
Continuous Punching process does not stop until the end of the
Mechanical
Hydraulic
Point The starting speed, acceleration and rapid traverse
speed can be set for each feeding axis individually.
Interpolation
Introduction
Feeding signal as the off clutch signal
by a separate switch signal
The system will pause after punching a hole
program
The punch main drive is mechanical
The punch main drive is mechanical flywheel
Feeding axes arrive simultaneously