Setting Protocols; Changing Protocol Settings - Brother HL-4200CN User Manual

Setting Protocols

When the printer is shipped from the factory, all protocols except FTP are active by default. Normally
if you are connecting a new printer to a network for the first time, you will not need to perform the
operations described in this section. If you need to change any of the default protocol settings, follow
the steps outlined in this section.
The printer settings are completed. Proceed to Confirming Settings on page 1-9.
Supported Protocols:
For TCP/IP(LPD)
For port 9100
For IPP
For NetBIOS (transport protocol: TCP/IP)
For NetBIOS (transport protocol: NetBEUI)
For NetWare
For AppleTalk
To learn how to operate the control panel, see Basic Menu Operation on page 4-4.

Changing Protocol Settings

Ready to Print
Menu
1:System
Menu
5:Network
5:Network
Ethernet
5:Network
Protocol
Continued
LPD protocol
Port9100 protocol
IPP protocol
NetBIOS TCP/IP protocol
NetBIOS NetBEUI protocol
NetWare protocol
AppleTalk protocol
(The print screen. The printer is ready to print.)
1
Press the Menu button. The menu screen will appear.
(The menu screen)
2
Press the button 4 times.
3
Press the Form Feed/Set or
4
Press the button 3 times.
5
Press the Form Feed/Set or
button once.
button once.
PRINTER SYSTEM SETTINGS 1 - 8