Brother HL-4200CN User Manual page 108

Message
Push in the Tray
Empty
Exit Tray
Replace Black
Toner (K)
Reinsert Black
Toner (K)
Operation Error
Please Press Set
Operation Denied
While Printing
ServCallJ1
Close
Front Cover
Replace Magenta
Toner (M)
Reinsert Magenta
Toner (M)
Out of Memory
Please Press Set
Pull out the (Y)
toner seal
5 - 19 TROUBLESHOOTING
None of the trays are properly inserted.
Action:
Push the all paper trays completely back into the printer.
The face down tray is full.
Action:
Remove the paper from the face down tray.
The black toner cartridge is empty.
Action:
Replace the black toner cartridge.
See Replacing the Toner Cartridges (TN-12BK/Y/M/C) on page 7-1.
There is no black toner cartridge inserted in the printer or the cartridge is improperly
set.
Action:
Grip the levers at each end of the black toner cartridge with your fingers, then push
down firmly to rotate the levers forward to install the cartridge.
See Replacing the Toner Cartridges (TN-12BK/Y/M/C) on page 7-1.
The request from the computer could not be printed.
Action:
Press the Form Feed/Set button and cancel printing. Check the printer driver settings
and reprint.
An illegal operation was performed on the control panel during printing.
Wait until printing finishes.
This is a warning message. Contact your dealer or Brother Customer Service.
The front cover is open.
Action:
Make sure that the front cover is properly closed.
The magenta toner cartridge is empty.
Action:
Replace the magenta toner cartridge.
See Replacing the Toner Cartridges (TN-12BK/Y/M/C) on page 7-1.
There is no magenta toner cartridge inserted in the printer or the cartridge is improperly
set.
See Replacing the Toner Cartridges (TN-12BK/Y/M/C) on page 7-1.
There is not enough memory available for the printer to function normally.
Action:
Press the Form Feed/Set button and cancel printing. Install a memory expansion card
and reprint.
See Adding Expansion Memory on page A-10.
If you are unable to install a memory expansion card, try printing again after setting the
printer driver as follows:
• Turn off the Duplex Printing and Multiple Page settings.
• Change the setting in Document Types to Normal in the Graphics tab (Windows
or the General dialog box (Macintosh
See Help.
A toner seal is still left in the yellow toner cartridge.
Action:
Remove the top cover, then remove the toner seals that are still left in the yellow toner
cartridge.
Meaning and Action
®
). Note that this lowers image quality.
®
),