Electrical Connection - Rangemaster Classic 60 Gas User Manual

Check the appliance is electrically safe and gas sound when you have finished.
Fig. 7.5
Gas inlet block
800
600
All dimensions in millimetres
400
A
300
INSTALLATION
Points that must be checked during
fixed gas connection assembly
The method used to assemble a fixed gas connection (gas
connection made by threads, e.g. a nut) varies according
to the country you are in. The most common parts for your
country will be supplied with your appliance. Any other parts
required can be supplied as spare parts.
During connection, always keep the nut on the gas manifold
fixed while rotating the counter-part. Use appropriately-
sized spanners for a safe connection. For surfaces between
different components always use the seals provided in the
gas conversion kit.
The seals used during connection should also be approved
to be used in gas connections. Do not use plumbing seals for
gas connections.
Remember that this appliance is ready to be connected to the
gas supply in the country for which it has been produced.
The main country of destination is marked on the rear cover
of the appliance. If you need to use it in another country, any
of the connections in the figure below may be required. In
such a case, contact local authorities to learn the correct gas
connection.
The Cooker must be installed and maintained by a suitably
qualified gas registered technician in accordance with current
safety legislation.
WARNING: Do not use a naked flame to check for gas
n
leaks.

Electrical Connection

All external wiring must comply with the IEE Regulations
for the Electrical Equipment of Buildings. Connection to the
electrical supply is via a plug and socket.
WARNING: The electrical connection of this
n
appliance should be carried out by an authorised
service person or qualified electrician, according to
the instructions in this guide and in compliance with
the current local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
n
• Before connecting the appliance to the power supply,
the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for
correspondence to the available mains supply voltage,
and the mains electric wiring should be capable of
handling the appliance's power rating (also indicated on
the identification plate).
• During installation, please ensure that isolated cables
are used. An incorrect connection could damage your
appliance. If the mains cable is damaged and needs to
be replaced this should be done by a qualified person.
• Do not use adaptors, multiple sockets and/or extension
leads.
21