Anti-Tilting Kit - Rangemaster Classic 60 Gas User Manual

Check the appliance is electrically safe and gas sound when you have finished.
• The supply cord should be kept away from hot parts
of the appliance and must not be bent or compressed.
Otherwise the cord may be damaged, causing a short
circuit.
• If the appliance is not connected to the mains with a
plug, a all-pole disconnector (with at least 3 mm contact
spacing) must be used in order to meet the safety
regulations.
• The appliance is designed for a power supply of 220-240
V~. If your supply is different, contact the authorized
service personnel or qualified electrician.
• The power cable (H05VV-F) must be long enough to be
connected to the appliance.
• The fused switch must be easily accessible once the
appliance has been installed.
• Ensure all connections are adequately tightened.
• Fix the supply cable in the cable clamp and then close
the cover.
• The terminal box connection is placed on the terminal
box.
Three pin plugs to BS 1363 with a capacity of not less than
13 A must be used and fitted with a 13 amp fuse 'ASTA'
approved to BS 1362.
You must refit the cover after replacing the fuse. If the cover is
lost, the plug must not be used until a replacement cover has
been obtained from your supplier. The colour of the correct
fuse carrier is that of the coloured insert in the base of the
fuse recess, or stated elsewhere on the plug. Always state this
colour when ordering a replacement fuse carrier.
IMPORTANT: The wires in the mains lead are
n
coloured in accordance with the following code (Fig.
7.6 and Fig. 7.7):
• Green/Yellow (Earth) wire to the terminal marked "PE".
• Brown (Live) wire to the terminal marked "L".
• Blue (Neutral) wire to the terminal marked "N".
• For this connection, a 'Twin and Earth 6242Y' type cable
should be used.

Anti-tilting kit

The document bag (Fig. 7.8) contains an anti-tilting kit.
Loosely attach the antitilting bracket (1) to the wall using
the screw (2) and wall plug (3), following the measurements
shown in the figure and table below. Adjust the height of
the antitilting bracket so that it lines up with the slot on the
cooker and tighten the screw. Push the appliance towards the
wall making sure that the anti-tilting bracket is inserted into
the slot on the rear of the appliance (Fig. 7.9).
INSTALLATION
Neutral: to the
terminal marked N,
coloured Blue
1
Anti-tilting
Bracket
(x1) (will be
attached to the
wall)
A
22
Earth: to the
terminal marked E,
coloured Green/Yellow
Live: to the
terminal marked L,
coloured Brown
2
3
Wall
Anti-
tilting
bracket
B
Fig. 7.6
Fig. 7.7
Fig. 7.8
Screw (x1)
wall
plug (x1)
Fig. 7.9