Maintenance And Inspection; General Information - Bosch REXROTH mMS 4.0 Operating Manual

Training system mMS 4.0 | R901429162/04.16

12 Maintenance and inspection

This chapter describes the maintenance and inspection work which may
be carried out by trained personnel on the mMS 4.0 training system.
Maintenance and inspection work which may only be performed by specially
trained and qualified personnel is described in 13 "Maintenance work".

12.1 General information

 Report the faults which were identified to the responsible manager immediately
so as to be able to remedy them immediately. Note that small faults can lead
to big ones if these are not remedied in time.
 Only clean the plastic parts with a lightweight, damp cloth. Only use water
and a mild cleaning agent without chemical additives. Never use solvents or
aggressive cleaning agents.
Before using a cleaning agent, examine the usage instructions and possible
hazards in the user information and DIN safety data sheet.
 Never blow out the training system with compressed air as sensors and valves
of the functional assemblies may get damaged.
 If you must remove oil, use suitable binding agents and cleaning cloths.
 Protect the training system from dust and moisture to prevent it from being
contaminated and can be used for a long time.
 Store and dispose of ejected and consumed working materials and
consumables appropriately in accordance with legal requirements.
In case of doubt, get information about the type of storage and disposal
provided by the material manufacturer/supplier.
Bosch Rexroth AG 61/68
Maintenance and inspection