Manual Mode Operation; Operating Single Step Mode - Bosch REXROTH mMS 4.0 Operating Manual

54/68 Bosch Rexroth AG
Description of the operating functions

10.2 Manual mode operation

Risk of damage!
Before initiating a program, all work pieces are removed from the training
system and loaded into the racks. At the manual mode Station 3 either "Check
Stock" or "Clear Stock" must have been performed.
The pinning unit must be filled with pins. A friction-free processing of the system
is ensured.
To launch the existing programs at each station in manual mode, proceed
as follows:
Ensure that the EMERGENCY STOP button is unlocked.

The PLC must display "RUN" on the display.

Choose manual mode using the authorization key-switch of the machine

operating panel to position 0.
The buttons to be pressed flash.

Actuate the reset button.

Connect the "Power on" output (Station 3).

Each actuator can be actuated individually.

The conveyor belt can be moved in both directions.

Short-stroke buttons on the actuators can only be operated in manual mode.

10.3 Operating Single Step mode

Risk of damage!
Before initiating a program, all work pieces are removed from the training
system and loaded into the racks. At the manual mode Station 3 either "Check
Stock" or "Clear Stock" must have been performed.
The pinning unit must be filled with pins. A friction-free processing of the system
is ensured.
To launch the existing programs at each station in single step mode, proceed
as follows:
Ensure that the EMERGENCY STOP button is unlocked.

The PLC must display "RUN" on the display.

Choose Single step mode using the authorization key-switch of the machine

operating panel to position 3.
The buttons to be pressed flash.

Actuate the reset button.

Connect the "Power on" output (Station 3).

Press the Start button.

Press the Start button again after each logical step.

The PLC program runs automatically with each press of the "Start" button,
the work pieces must be removed by hand from the end of the conveyor and
the ramp. After a cycle has been run through completely, the cycle can begin
from new. In the event of an interruption, press the "Start" button again.
Training system mMS 4.0 | R901429162/04.16
CAUTION
CAUTION