Check The Pneumatic Supply - Bosch REXROTH mMS 4.0 Operating Manual

46/68 Bosch Rexroth AG
Set-up, installation and commissioning
Connection
9.2

Check the pneumatic supply

The mMS 4.0 training system is completely pre-assembled and tested at the
factory. During transportation, however, faults or damage may arise on the mMS
4.0 training system.
Before commissioning of the pneumatic system always check
 the hose system for damage;
 the proper seating of the hose couplings;
 whether any of the parts can be damaged;
 whether all of the attachment parts are properly connected;
Fig. 19: Pneumatic diagram profile trolley
Connect each station's maintenance unit to the air supply which is on

the extreme left.
Next, connect the stations together by making a connection between

the shutoff valve on each station with the maintenance unit of the next station.
Fig. 20: mMS 4.0 installation
Observe the shutoff valves for the air supply on each station.

The air supply is passed on from each station to the next.

The pneumatic circuit diagrams of each station can be found in the enclosed
documentation CD.
Training system mMS 4.0 | R901429162/04.16