Brother HL-2400C Series User Manual page 177

USER'S GUIDE
5-36
The following capacity of SIMM can be installed:
• 1 Mbyte HITACHI HB56D25632B-6A, -7A, -8A
MITSUBISHI MH25632BJ-7, -8
• 2 Mbyte HITACHI HB56D51232B-6A, -7A, -8A
MITSUBISHI MH51232BJ-7, -8
• 4 Mbyte HITACHI HB56A132BV-7A, -7AL, -7B, -7BL, -8AL, -8B,
MITSUBISHI MH1M32ADJ-7, -8
• 8 Mbyte HITACHI HB56A232BT-7A, -7AL, -7B, -7BL
MITSUBISHI MH2M32EJ-7, -8, MH2M32DJ-7, -8
• 16 Mbyte TOSHIBA THM324000BSG-60, -70, -80
• 32 Mbyte TOSHIBA THM328020BSG-60, -70, -80
In general, the SIMM must have the following specifications:
Type: 72 pin and 32 bit or 36 bit output
Access Time: 80 nsec. or less
Capacity: 1, 2, 4, 8, 16 or 32 Mbyte
Height: 46mm (1.8 inches) or less
Parity: NONE
EDO RAM can be used.
Notes

There might be some SIMMs which will not work with this printer.

For more information about the cards, consult the dealer where you
purchased the printer.

For the latest information: http://www.brother.com
There are 40 bit output SIMMs for workstations. Such SIMMs do not fit
this printer.
For SIMMs and installation, consult the dealer where you purchased the
printer.
Note
This printer has 3 SIMM slots. The maximum size for each slot is a
32MB SIMM. For the 32MB standard memory model, a 16MB SIMM is
pre-installed. If you want to expand the RAM size to 112MB, replace the
16MB SIMM with a 32MB SIMM.
When you install SIMMs, follow these steps:
1. Turn off the printer and unplug the power cord from the AC outlet.
Note
Be sure to turn off the power to the printer before installing or removing
the SIMMs.
-8BL