Mode Button Settings In Hp Pcl5C, Epson Fx-850, And Ibm Proprinter Xl Modes - Brother HL-2400C Series User Manual

MODE Button Settings in HP PCL5C, EPSON FX-850, and IBM
Proprinter XL Modes
The following table shows all the selections you can make with the Mode
button in the HP PCL5C, EPSON FX-850, and IBM Proprinter XL
modes.
Note
The mode menus and settings that can appear vary according to the
current emulation mode, printer status, and any options that may be
installed in the printer.
Mode Menu Setting Menu
INTERFACE MODE I/F=PARALLEL
I/F=RS-232C
I/F=EXPAND I/O
I/F=AUTO
Sub-Setting Menu Setting
HIGH SPEED=ON ON or OFF
BI-DIR=ON ON or OFF
exit Exit to INTERFACE MODE
BaudRate= 9600 150, 300, 600, 1200, 2400, 4800,
9600, 19200, 38400, 57600, or
115200 baud
CodeType=8 bits 7 or 8 bits
Parity =NONE NONE, EVEN, or ODD
Stop Bit=1 bits 1 or 2 stop bits
Xon/Xoff=ON ON or OFF
DTR (ER)=ON ON or OFF
Robust Xon=OFF ON or OFF
exit Exit to INTERFACE MODE
Available only when a commercial MIO card has been
installed.
MIO Setting The settings available on the
installed MIO card can appear
under the sub-setting menu.
exit Exit to INTERFACE MODE
TIME OUT= 5s 1 to 99 seconds
PRL Setting Bi-directional settings for AUTO
HIGH SPEED=ON ON or OFF
BI-DIR=ON ON or OFF
exit Exit to PRL Setting
RS-232C Setting Parameters for AUTO mode
BaudRate= 9600 150, 300, 600, 1200, 2400, 4800,
9600, 19200, 38400, 57600, or
115200 baud
CodeType=8 bits 7 or 8 bits
Parity =NONE NONE, EVEN, or ODD
Stop Bit=1 bits 1 or 2 stop bits
Xon/Xoff=ON ON or OFF
DTR (ER)=ON ON or OFF
Robust Xon=OFF ON or OFF
exit Exit to RS-232C Setting
CHAPTER 4 CONTROL PANEL
4–9