Installation - Dometic SANIPOTTIE 970 Series Instruction Manual

Portable toilets
Table of Contents

Advertisement

Empty holding tank
1. When tank level indicator shows "full,"
the lower tank. and open vent on top of holding tank.
2. Pull up on rear latch to separate upper tank
from lower tank. Carry lower tank to autho-

INSTALLATION

BE SURE TO READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING PORTABLE TOILET.
Models 974, 975
1. Place toilet on level floor in desired location. Mark
floor at front of toilet, then set toilet aside. Pull
locking handle out of toilet (located at bottom front of
toilet).
2. Align mounting template with mark on floor.
3. Use center punch to mark fastener hole locations for
brackets. Set template aside.
4. Drill pilot holes with 3/32-in. (2.4 mm) drill bit. Align
centers of bracket slots with the drilled holes. With
supplied fasteners, attach brackets to floor so that
they can be slid with little effort.
5. Position toilet into the mounting brackets and insert
the locking handle into front of toilet. The toilet
should be securely held in position by the brackets. If
toilet is not secure, adjust back brackets and/or front
bracket until toilet is secure.
6. Once the brackets are properly positioned, remove
locking handle and set toilet aside. Firmly tighten
fasteners to secure the brackets in place.
7. Position toilet into mounting brackets and reinsert the
locking handle.
Models 974MSD, 975MSD WARNINGS
Dometic marine toilet systems must be installed
according
to
procedures.
Equipment
personnel or death could result from improper
installation.
DOMETIC
4
Dometic's
recommended
damage,
injury
CORPORATION
970 SERIES PORTABLE TOILETS
3. Rotate discharge spout away from tank, empty
Empty tank.
4. If water is available, rinse lower tank before
970 SERIES
TOILET
LOCKING
HANDLE
ACCEPTS NO RESPONSIBILITY OR LIABILITY
FOR DAMAGE TO EQUIPMENT, OR INJURY OR
DEATH TO PERSONNEL THAT MAY RESULT
FROM IMPROPER INSTALLATION, SERVICE
OR OPERATION OF THIS PRODUCT.
to
WARNING!
HAZARD OF FLOODING – If the toilet
system is connected to ANY through-the-hull
MOUNTING BRACKETS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents