Components; Installation - Dometic 310 Instruction Manual

Dometic Model 310 Toilet
4.4 Rough-in dimensions
Ref. Dimension/Description
A 10 in . / 254 mm
B Floor flange
C 11 in . / 279 mm
D 11 in . / 279 mm
5

Components

Ref. Description
A Toilet seat
B Flush ball seal
C Toilet bowl
D Toilet base
E Flush pedal
F Floor flange seal
6

Installation

Note
Be sure foot pedal, when pressed, touches same flat surface on which toilet is installed .
Note
Be sure to follow recommended installation requirements in section 4 .2 of this manual .
6.1 Tools required
• pliers or adjustable wrench
• 7/16-in . / 11 mm wrench
6.2 Toilet installation
1 . To replace an older toilet, turn off water supply to toilet . Remove and drain water supply line .
Remove toilet hold-down bolts/screws . Remove toilet from floor . Remove and discard old floor
flange seal and hold-down bolts . Verify center of floor flange is at least 10 inches / 254 mm
from back wall (fig .
debris or sealant .
2 . If installing a new floor flange, make certain that toilet mounting holes are located at the correct
angle (fig . B, page 2) . Floor flange must be secured to floor with a minimum of four screws
3
(8 is preferred) . Insert two supplied T-bolts into slots in floor flange (fig .
6
(fig . 3
(fig . 1 , page 2)
A, page 2) . Make sure top surface of floor flange is clean and free of any
3
, page 2)
Ref.
E
F
G
Ref.
G
H
I
J
Refer to complete parts list (available online at
www .dometic .com) for additional information .
Specifications / Installation
Dimension/Description
Left wall
Back wall
Right wall
Description
Vacuum breaker cover
Vacuum breaker
Water valve
Floor mounting hardware kit
4 , page 2) .