Product Life; Care And Cleaning; Specific Reasons For Erroneous Measuring Results - ADA INSTRUMENTS 6D SERVOLINER Operating Manual

8 English
TO CHECK LEVEL
Choose a wall and set laser 5M away from the wall. mark cross point on
the wall. Turn the line laser so that the beam is displaced approximately
2.5m to the left. Horizontal line must be in the "accuracy" range (see specif.)
at the same height with the cross point. Repeat the same steps, moving
the laser level to the right. NOTE: do not displace the rotating axis when
checking.
6
CHECK PLUMB
Choose a wall and set laser 5m away from the wall. Hang a plumb line 2,5
m long. Turn on the laser and aim the vertical laser line to the plumb. The
accuracy of the line is in the range, if the vertical line doesn't exceed (up or
down) the half of the value of the accuracy that is shown in the specifica-
tions (±3 mm/10 m).

PRODUCT LIFE

Product life of the tool is 7 years. The battery and the tool should never
be placed in municipal waste. Date of production, manufacturer's contact
information, country of origin are indicated on the product sticker.

CARE AND CLEANING

Please handle line laser with care. Clean with soft cloth only after any use.
If necessary damp cloth with some water. If instrument is wet clean and
dry it carefully. Pack it up only if it is perfectly dry. Transport in original
container/case only.

SPECIFIC REASONS FOR ERRONEOUS MEASURING RESULTS

• Measurements through glass or plastic windows;
• Dirty laser emitting window;