Declaration of Conformity
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
Changes or modifications not expressly approved by Futurecom Systems Group, ULC.
could void the User's authority to operate the equipment.
Important Safety Information
The DVRS Repeater is intended for use in occupational / controlled conditions, where
users have full knowledge of the operator exposure and can exercise control over the
operator exposure to meet FCC/ISED limits. This radio is NOT authorized for general
population, consumer, or any other use.
Notice to Users (FCC/ISED)
To satisfy FCC/ISED RF exposure requirements for mobile transmitting devices, refer to
the RF Safety Booklet
antenna of this device and persons during operation. To ensure compliance, operations
at closer than this distance is not allowed.
Futurecom requires the P25 DVRS operator to ensure FCC/ISED Requirements for Radio
Frequency Exposure are met. The minimum distance between all possible personnel and
the body of the DVRS equipped vehicle is specified in the RF Safety Booklet
observe the Maximum Permissible Exposure (MPE) distance exclusion area around the
antenna may expose persons within this area to RF energy above the FCC exposure limit
for bystanders (general population).
It is the responsibility of the repeater operator to ensure that MPR limits are observed at
all times during repeater transmissions. The repeater operator must ensure at all times
that no person comes within MPE distance from the antenna.
[1]
Refer to RF Safety Booklet available on the Futurecom website.
[2]
Refer to RF Safety Booklet available on the Futurecom website.
8M093X01 R1.0
for TX – RX duty cycle and a separation distance between the
[1]
[2]
. Failure to
7
Need help?
Do you have a question about the DVR-LX and is the answer not in the manual?