Tools Required; Customer Provides; Unpack And Inspect The System; Contents Of Adtran Shipment - ADTRAN TRACER 5045 System Manual

Section 4, Network Turnup Procedure
1. INTRODUCTION
This section discusses the installation process of the TRACER 5045 system.
Changes or modifications not expressly approved by ADTRAN could void the user's
authority to operate the equipment.
2.

TOOLS REQUIRED

The tools required for the installation of the TRACER 5045 are:
• VT100 terminal or PC with terminal emulation software
• RS-232 (DB-25 male for TRACER 5045) cable for connecting to terminal
To prevent electrical shock, do not install equipment in a wet location or during a lightning
storm.
3.

UNPACK AND INSPECT THE SYSTEM

Each TRACER 5045 is shipped in its own cardboard shipping carton. Open each carton carefully and
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in
transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Customer
Service, Product Support Information, and Training information in the front of this manual).

Contents of ADTRAN Shipment

Your ADTRAN shipment includes the following items:
• TRACER 5045 Unit
• TRACER 5045 Quick Start Guide
• TRACER 5045 Documentation CD

Customer Provides

The following items are necessary for the installation of the TRACER 5045 system and are not provided
by ADTRAN:
• 21 to 60 VDC power source (or AC adapter available from ADTRAN P/N 1280650L1), either polarity
referenced to ground
• Antenna and mounting hardware
• Antenna feedline cable
• Ethernet cables
36 © 2003 ADTRAN, Inc.
TRACER 5045 System Manual
612805045L1-1A