Alto-Shaam 300-TH/III Manuallines page 15

O PER ATION
programming a preset
Select the product to be programmed and begin programming with the oven control power O
Press and release control o
will be indicated by an illuminated green indicator light located in the upper left corner of the
O /O
n ff
illuminated and the last set hold temperature will be displayed.
To set Cook temperature — Press c
set cooking temperature is displayed. To change the cook temperature, press the u
a keys.
rrow
if cooking by time — press the t
I
cooking time will be displayed. To change the set time, press the u
o
display will alternate between the set temperature and the elapsed time.
if cooking by probe — press the p
I
set internal product temperature will be displayed. To change the set temperature, press the u
o
d a
own
the probe temperature.
I
To set Hold temperature — Press the h
I
illuminated. To change the hold temperature, press the u
o
alternate between the set hold temperature and the amount of time the product has been in the hold
o
mode. Oven will remain in the h
I
To set Smoke time — Press s
I
key. The last set time will be displayed.
o
o
Select a letter code for the product programmed by the previous steps. Press and hold the selected p
I
key for two seconds. When the preset has been saved, you will hear a one second beep and the preset
I
light will illuminate.
o
o
Note: Only one preset can be programmed at a time. If programming an additional preset is
desired, the unit must be started and stopped either by cycling the power to the cavity or by
pressing the S
for the next product to be programmed. Settings can be manually changed for the next product
and an alternate pre-programmed letter key selected.
erasing a preset
To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven
cannot be running a p
reset
When the oven is in the power-up hold mode or in the preheat mode, press and hold the c
the appropriate letter p
beep for one second.
ImporTaNT -
key, it is very important to make a written permanent record of the product and the program
letter assigned. menu card (pE-23384) is provided for this purpose.
G EN E R AL OPE R AT I O N - D EL UXE C ON TRO L OV EN S
/o
n ff
key. The oven will begin operating in the hold mode. The amber H
I
o
I
o
I
key. The display will alternate between the set temperature, the elapsed time, and
rrow
o
moker
I
o
/S key. The last p
tart top
Menu program.
key to be erased for two seconds. When the preset has been erased the oven will
reset
after programming a specific product into memory in a programmable preset
cooking guidelines
key. The oven will beep for one second and power to the unit
key. Oven preheat indicator will illuminate and the last
ook
key. The green t
ime ime
key. The green p
robe
key. The green cook indicator light will remain
old
mode until the o
old n
key. To set the smoke time desired, use u
key used will be the oven cooking run sequence
reset
-
deluxe control
old
indicator will illuminate and the last set
or d a
p own
indicator will illuminate and the last
robe
or d a key. The display will
p own rrow
/o key is pressed.
ff
p
ancel
•
12
.
ff
indicator will be
or d
p own
key. The
rrow
or
p
or d a
own rrow
reset
key and then