Kasco J Series Operation & Maintenance Manual page 2

Contents
General Instructions �����������������������������������������
Important Safety �����������������������������������������������
Unit Specs ��������������������������������������������������������
Parts Included ���������������������������������������������������
Assembly Instructions ���������������������������������������
Included Nozzles ����������������������������������������������
Unit Installation Instructions ������������������������������
GENERAL INSTRUCTIONS
INSPECT THE SHIPMENT: Immediately inspect your Kasco fountain shipment for any visible damages� Also cross reference the parts
supplied with the Parts Included sheet to check for shortages� Shortages should be reported immediately to your Kasco Marine distrib-
utor or representative and damages reported to your carrier and Kasco Marine�
ASSEMBLY & INSTALLATION: Please see the proper Assembly and Installation Instructions enclosed in this manual. Each is specific
for your model and size of fountain�
• Use a nylon tie to help keep the power cords for the unit and lights free of the propeller by tying each cord to either side of
the float. If you have a light kit, make sure that the unit cord is tied to one side of the float and the light cord to the other for
balance�
• It is extremely important to test the GFI breaker in the control panel upon each installation/re-installation of the unit to ensure
proper functioning�
USE AND OPERATION: Kasco fountains are designed and engineered for continuous duty, such as on fish farms or other aquaculture
applications, or on-demand use, as needed in a recreational water feature. During flotation operation, the water is pulled from 360
degrees around the unit and from below the unit. The water is pulled upward and thrust through the flotation collar into the air.
Your Kasco Marine fountain is ready for immediate use (after installation)� The motor and ball bearings are submerged in oil, and no
further lubrication is needed� Make sure to keep the motor housing clean from hard water deposits and/or algae� (See Maintenance
Recommendations�)
It is extremely important that proper and sufficient voltage (120V or 240/208V) is supplied to the Fountain motor. Each 120V Fountain
is supplied with a UL and CSA approved C-25 GFI Protected Control Box� The Fountain is to be plugged into the C-25 outlet labeled
"UNIT" and the C-25 plugged into a properly grounded receptacle. Each 240V Fountain is supplied with a UL and CSA approved C-85
GFCB Protected Control Panel. The Fountain is to be hardwired into C-85 panel. The C-85 must have 4 wire service (L1, L2, neutral,
and ground) installed by a qualified electrician. It is extremely important to test the GFI breaker in the control panel upon each installa-
tion and re-installation and every month thereafter to ensure proper operation� (See Control Panel Instructions�)
3400 - 4400 J-SERIES FOUNTAIN
Maintenance Recommendations ���������������������
2
Repair �������������������������������������������������������������
3
Non-Warranty Repairs ������������������������������������
3
Troubleshooting Tips ��������������������������������������
4
Replacement Parts �����������������������������������������
5
Repair Contact Form ��������������������������������������
7
8
This Kasco product is the result of years of innovation, and we are confident that
you will be impressed with its quality and performance� If you have any questions
about assembly, installation, or maintenance, please reach out to our friendly and
knowledgeable customer care team� Thank you for trusting Kasco�
715.262.4488 www.kascomarine.com
2
MANUAL
9
10
11
12
13
14
sales@kascomarine.com
884180 / 2021.1.3