Care And Maintenance; Replace The Battery - Power Fist 8662330 User Manual

8662330
When the workpiece is ready, turn the angle finder
on again and adjust the fold-out arm until the LCD
screen reading matches the recorded angle. Place
the angle finder on the workpiece and mark the
angle (Fig. 3).
CHANGING THE ANGLE TO A
MITRE ANGLE
Measure the angle and press the HOLD button
(F). Press the MTR button (E) to convert the angle to the correct mitre angle.
Set your mitre saw to this angle for the cut.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.

REPLACE THE BATTERY

Change the battery when the LOW BAT (battery) indicator
(M) appears in the LCD Screen (G). Measurements are still
possible when the battery is low, but the readings may be
inaccurate.
Remove the two screws and pull off the end cap (J). Take
the battery out and disconnect it from the battery snap.
Install a new battery, ensuring the terminals are firmly
snapped into place. Insert the battery into the case and
reinstall the end cap and screws.
6
Digital Angle Finder
For technical questions call 1-800-665-8685
V4.0
Fig. 3
Fig. 4