Pressure Drop; Care And Maintenance - Power Fist 8843617 Manual

V1.0
5. Press the trigger lever (#16) to operate. Make sure the needles are not
touching the workpiece surface until the tool is running.
6. Place the vibrating needles on the work surface. Move the needle
scaler around in the area from which you wish to remove the material.
7. Apply light pressure on the tool while in use. Heavy pressure can
damage the work surface.
8. Do not hold the needle scaler in any one area of the work surface for
more than a few seconds. Longer intervals could damage the surface.
9. If the needle scaler will not remove the material from the surface after
a few brief attempts, do not continue. Use another method to remove
the material.
10. When finished with the tool, turn off the air compressor, disconnect
the air hose and discharge any residual air remaining in the tool.
11. Clean the tool of accumulated dust or debris before storage.

PRESSURE DROP

Apply the air consumption and pressure rate numbers to the tool's air inlet, not
the compressor's outlet. Calculate the pressure drop for your air supply set-up
and increase the compressor outlet pressure to compensate. Make sure you do
not exceed the maximum pressure for any part of your air supply system.
Installing a pressure gauge at the tool inlet is the best way to measure the
air pressure and adjust the compressor's output.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced
by an authorized technician. Only use identical replacement parts
when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool clean, dry and free from oil/grease at all times.
6. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
Visit www.princessauto.com for more information
Air Needle Scaler 8843617
9