Installation And Connection; Operation - Bartscher 191.001 Instruction Manual

•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of
the device and is not heat sensitive.
•
Do not place the unit on a surface which is sensitive to water. Spraying water may
cause damage.
•
Never place the unit under a hanging cupboard.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
5.3 Operating
•
Prior to first use clean the unit and accessories (see also 6.2 „Cleaning").
•
Fill the water reservoir to its maximum capacity (as indicated) and boil. Pour the
water out.
•
Repeat 2-3 times.
•
Next, fill the reservoir with the required amount of fresh water (up to the maximum
indicated capacity)
- 29 -