Installation And Connection - Bartscher 200.264 Instruction Manual

WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that
of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

CAUTION!
Installation and connection of the device may only be performed by certified
specialists.
•
Unpack the device and remove the packing material. Remove the entire protective
foil from the device.
•
Place the device on a flat, secure surface that can support its weight.
•
Never place the device on a flammable surface (e.g. carpet).
•
Do not place the device near an open flame, electric ovens, coal furnaces or other
sources of heat such as direct sunlight. High temperatures may have a negative
effect on cooling power and increase energy consumption.
•
Place the device so as to allow proper air circulation. Keep a minimum distance of 5
cm from the rear, 10 cm at the sides and 30 cm from the ceiling or shelves.
•
Never cover the device's ventilation ducts.
•
Do not place the device where high levels of ambient humidity occur. Such high
humidity may damage the device.
•
Only move the device by lifting it, to avoid damage to the adjustable legs and other
equipment.
•
If the device has been transported in an upright position, wait 2 hours prior to
connecting the device (integrated condenser) to a power source.
•
To regulate the device's height, turn the adjustable legs until the device is straight
and level.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
- 25 -