Installation And Connection - Bartscher SNACK A162402E Instruction Manual

5.2 Installation and connection

CAUTION!
The device may be installed by a qualified specialist only.
•
Discard the complete packing material after unpacking the device.
•
Place the device on top of a solid, even, safe and stable surface that tolerates the
weight.
•
Not at any time you should place the device on top of an inflammable surface (such
as: table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
Avoid installation spots with close contact to water.
•
Remove the lid, basket, handle and other accessories from the device.
•
Detach the switching unit from the device by lifting it carefully (until you hear a
„CLICK"-sound).
•
Screw the handles with openings facing down into both sides of the casing. To do
so, insert the mounting screws into the handles from the inside of the casing.
•
Wash the cover, oil reservoir, frying basket, heating element shield and casing with a
mild cleaning agent whilst taking care to avoid the introduction of moisture to the
electrical installations and switching unit. Dry the unit thoroughly!
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
•
Two separate sockets are necessary for the dual fryer.
•
Each electrical circuit in the socket must be secured to at least 16A. Only connect the
unit directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed from
its socket in case of necessity.
- 26 -