Configuration In Infrastructure Mode; Before Configuring The Wireless Settings - Brother HL-4040CN Network User's Manual

Configuration in Infrastructure mode

Note
If you are going to connect the printer to your network, we recommend that you contact your system
administrator prior to installation.

Before configuring the wireless settings

IMPORTANT
Before configuring the wireless settings, confirm your network environment.
• The users that can temporary connect with a network cable for configuration:
You do not need to reset the print server and enable the WLAN setting. Go to Configure the wireless
settings on page 64.
• The users that do not have a network cable or cannot temporarily connect the Brother wireless
device to your access point:
If you have previously configured the wireless settings of the printer, you must reset the print server back
to the default factory settings (see Restoring the network settings to factory default on page 105) and
enable the WLAN setting from the control panel. See Set the wireless network enable using the contol panel
on this page.
Set the wireless network enable using the contol panel
a
Make sure that the front cover is closed and the power cord is plugged in.
b
Turn on your printer and wait until the printer is in the Ready state.
c
Press any of the Menu buttons (+, -, OK or Back) to take the printer offline.
Ready
h
Select ab or OK
Machine Info.
d
Press the + or - button to select LAN.
Select ab or OK
LAN
e
Press OK to move to the next menu level.
LAN
Wired
f
Press the + or - button to select WLAN.
LAN
WLAN
Wireless configuration for Macintosh
®
using the Brother automatic installer application
5
5
5
5
63