Brother HL-4040CN Network User's Manual page 49

l
To communicate with the un-configured wireless printer, temporarily change the wireless settings on
your computer to match printer's default settings shown on this screen. Check the box if you confirm,
and then click Next.
Note
• If a message to restart your computer appears after the wireless settings have been changed, restart your
computer and then go back to step c and continue with the install skipping steps j, k and l.
®
• For Windows XP SP2 users:
You can temporarily change the wireless settings on your computer, following the steps below:
1
Click Start and then Control Panel.
2
Click Network Connections icon.
3
Select and right click Wireless Network Connection. Click View Available Wireless Networks.
4
You can see the Brother wireless printer in the list. Select SETUP and click Connect.
5
Check the Wireless Network Connection status. It may take a few minutes to change from 0.0.0.0.
to 169.254.x.x IP address to be shown on screen (where x.x. are numbers between 1 and 254).
Wireless configuration for Windows
®
using the Brother automatic installer application
4
42