Wlan Menu Options (Hl-4070Cdw Only) - Brother HL-4040CN Network User's Manual

100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Full Duplex (10B-FD) or Half
Duplex (10B-HD) fix the print server link mode. This change is valid after the print server has been reset. The
default setting is Auto.
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
Set to Default
You can restore the Wired menu settings to factory default.
Wired Enable
You can enable and disable the wired network connection by selecting On or Off.

WLAN menu options (HL-4070CDW only)

See Wired menu options on page 99 for detailed information of the Wired menu option.
TCP/IP
See TCP/IP on page 99 for more information.
Setup WLAN
Setup Wizard
The Setup Wizard guides you through the wireless network configuration. For more information, see Using
the Setup Wizard from the control panel on page 25.
SecurEasySetup
The SecureEasySetup™ software allows you to configure the wireless network easier than configuring it
manually. By pushing a button on the wireless router or access point, you can complete setup and secure
the wireless network. Your router or access point must also support SecureEasySetup™. See Using the
SecureEasySetup™ software to configure your printer for a wireless network on page 23.
WLAN Staus
Status
This field displays the current wireless network status; Active (11b), Active (11g),
Wired LAN Active, WLAN OFF or Connection NG.
a
Press the + or - button to select LAN. Press OK.
b
Press the + or - button to select WLAN. Press OK.
c
Press the + or - button to select WLAN Status. Press OK.
d
Press the + or - button to select Status. Press OK.
e
The current wireless network status will be displayed; Active (11b), Active (11g),
Wired LAN Active, WLAN OFF or Connection NG
Control panel setup
10
10
10
10
10
10
10
102