Netbios/Ip; You Can Enable And Disable The Netbios Facility To Obtain The Ip Address; Enet; Set Default - Brother HL-5270DN Network User's Manual

■
IPV6
This printer is compatible with IPv6, the next generation internet protocol. If you want to use the IPv6
protocol, visit http://solutions.brother.com for more information.

NETBIOS/IP

You can enable and disable the NetBIOS facility to obtain the IP address.

ENET

Ethernet link mode. AUTO allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T
full or half duplex mode by auto negotiation.
100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Full Duplex (10B-FD) or Half
Duplex (10B-HD) fix the print server link mode. This change is valid after the print server has been reset. The
default setting is AUTO.
Note
If you incorrectly set this value, you may not be able to communicate with your print server.

SET DEFAULT

You can restore the WIRED menu settings to factory default.

WLAN menu options (HL-5280DW only)

See WIRED menu options on page 8-5 for detailed information of the WIRED menu option.

WLAN ENABLE

You can enable and disable the wireless network connection by selecting ON or OFF.

TCP/IP

See TCP/IP on page 8-5 for more information.
Control panel setup
8
8 - 8